







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Wellborn Driveway & Pavers: The Long Beach Owner’s Guide
Wellborn paver driveways in Long Beach are installed as system assemblies, so a failing edge, sunken corner or loose field unit is almost always a base or joint problem rather than a bad piece of stone. Full paver driveway installation in Long Beach runs $7,000 – $18,000, and repair work on Wellborn systems is typically scoped after a site visit because the cause sits under the surface, not on it. We install and service Wellborn-compatible driveway and paver work across Long Beach, and we’re an independent remodeling contractor, not affiliated with Wellborn.
Owners usually find the problem the same way. A tire drops half an inch pulling into the garage. A line of joints washes out after a winter rain. A paver near the apron rocks underfoot, or weeds start threading through the same three courses every spring. Long Beach sits close enough to the coast that salt air and marine moisture work on the joints and the slab beneath the pavers year-round, so the first sign is often sand loss and a soft edge, not a broken stone.
Which Wellborn Models This Applies To

Wellborn paver systems are sold as families: a field paver in standard thickness, a border course, and edge restraint hardware that holds the whole field in place. The pieces that fail first are the edge restraint, the bedding sand and, on driveways, the base course. Matching a replacement correctly means matching the family, the nominal thickness and the joint width the original was laid to, because a paver that’s a quarter inch off in thickness won’t sit flush with the field around it and will rock loose within a season.
Identify what you have before you buy anything. Look for a stamp or molded mark on the underside of a loose unit, measure a single paver face and its thickness, and measure three joint widths with a tape. Photograph the edge detail where the field meets the driveway apron. Those three pieces of information – family marking, thickness, joint width – are what let us match the piece to your actual Wellborn system.
The OEM-versus-aftermarket question matters here. A genuine Wellborn unit guarantees a dimensional match to the existing field. A quality aftermarket paver can work if the thickness and joint width line up, which is often the case on a repair where color variation is acceptable. Where a repair sits in the middle of a visible field, we usually recommend matching the original family so the patch doesn’t read as a patch.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Wellborn Driveway & Pavers Is Failing
- Sand washing out of the joints. Rainfall and hose runoff strip the joint sand, and once it’s gone the pavers lose their interlock and shift. In Long Beach, the first heavy rain after a dry summer usually shows it as dark joint lines.
- Pavers rocking underfoot or under a tire. A rocking unit means the bedding layer beneath it has settled or failed, often from poor drainage at that spot. Replacing the paver alone won’t fix it; the base under it needs attention.
- Edge restraint lifting or pulling away. The restraint is what keeps the field from spreading, and when it fails the outer course opens up. This is the most common cause of a spreading driveway edge.
- Efflorescence and white mineral bloom. A chalky white haze on the paver face points to moisture moving through the system, not a dirty surface. It usually means water is getting trapped under the pavers instead of draining away.
- Weeds and ant mounds along joint lines. Persistent weeds in the same joints signal lost joint sand and a base that’s holding moisture, which is exactly what roots and colonies move into.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

For Long Beach, paver driveway installation runs $7,000 – $18,000, and a full driveway replacement sits at $5,000 – $14,000 depending on whether the base is rebuilt or reused. Where a smaller section is failing, we scope a targeted repair first, and driveway sealing at $250 – $700 is often the right follow-up to protect a sound field after it’s been corrected.
What drives the range: driveway square footage, whether the base course gets rebuilt, the paver family you match to, drainage corrections, and how much edge restraint needs replacing. We give a written, line-item price before any work starts, so the number on day one is the number on the invoice. The work carries our 365-Day Done Right Promise, backed in writing: if the repair or install fails inside that period, we come back and fix it at no charge. If a repair fails, the return visit is free.
DIY or Call Us?
You can safely check joint sand depth, measure a paver, photograph the edge restraint and note where the driveway holds water. Those checks help us and cost you nothing. What goes wrong on the DIY side is the base. Reset a loose paver onto a compacted base you haven’t verified and it fails again within a season. Skip the edge restraint and the field spreads. Try to fix drainage by adding fill and you push water toward the slab under the house.
Driveway pavers aren’t high-tension or electrical work, so there’s no injury risk in looking. The risk is a repair that looks finished and then fails again within a year. Call us at (833) 510-6967 to schedule a site visit and get a written scope before anything is pulled up.
FAQs

A properly installed Wellborn paver driveway should hold up 20 to 30 years, and the pavers themselves often outlast the base and joints. The realistic failure points are joint sand, edge restraint and drainage, which is why resealing every few years ($250 – $700) extends the life of the field. Coastal moisture and salt air make joint maintenance more important here than inland. Call (833) 510-6967 for an assessment of your driveway.
Yes, often. If the field units are intact and the failure is localized – an edge, a single course, a low spot holding water – a targeted repair usually costs a fraction of a full replacement. Replacement makes sense when the base is consistently failing across the whole driveway. A site visit tells you which situation you’re in. Call (833) 510-6967 and we’ll give you a written scope either way.
A localized paver repair is usually a short job, often completed in a single visit once the right units are on hand. A full driveway replacement takes longer because the base has to be excavated and rebuilt before any pavers go down. We give you a written schedule with the price, and we arrive in the window we promised. Call (833) 510-6967 to schedule your estimate.
We match by family marking, nominal thickness and joint width, using photos and measurements from your driveway. Where the original family isn’t available, we recommend a quality aftermarket paver that matches dimensionally so the repair sits flush with the field. We don’t claim to keep parts in stock or on a truck; we source to your specific system. Call (833) 510-6967 for a free estimate and part matching.
Our technicians have up to 22 years of experience, they’re background-checked and arrive in uniform, and a live person answers the phone around the clock. We also work with KraftMaid, Cambria and Silestone on the interior side of the house when a driveway project turns into a bigger plan. Call Penhallow Remodeling Long Beach at (833) 510-6967 for a free estimate – written, line-item, and backed by our 365-Day Done Right Promise.
Written by the team at Penhallow Remodeling Long Beach, serving Long Beach and nearby areas.












