







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Delta Home Additions & ADU: The Long Beach Owner’s Guide
Home additions in Long Beach typically run $45,000 – $130,000, and detached or attached ADUs run $90,000 – $220,000, with Delta fixtures and finishes included in the spec when homeowners request them. Those numbers reflect a full build, not a repair: new foundation, framing, roof tie-in, permits, and interior finish-out. Most Long Beach owners don’t start here looking for a “part.” They start after a failed inspection or a slow leak at a shower valve, then realize the addition they inherited has Delta plumbing and trim throughout.
Which Delta Models This Applies To

Delta isn’t a single product line, and that trips people up. The Delta name on a faucet, shower trim, or tub spout tells you almost nothing about which cartridge or rough-in valve sits behind the wall. Long Beach homes with additions built in the 1980s through the 2000s commonly carry Delta Monitor 1200 or 1300 series valves, while newer builds and remodels often use the Monitor 14 or 17 series with a separate temperature-limit stop. Identify your valve before ordering anything: pull the handle and look for the stamped series number on the escutcheon, or snap a photo of the cartridge once it’s out.
The OEM-versus-aftermarket call matters more for Delta than for most brands. Genuine Delta cartridges carry the manufacturer’s finish and function warranty; quality aftermarket replacements can cost half as much but often use slightly different seal geometry that shows up as a slow drip within a year. If the part sits behind a wall you don’t plan to open again, we spec OEM for Delta. We also install KraftMaid, Cambria and Silestone in the kitchens and baths that feed these additions, so the finish side stays coordinated.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Delta Home Additions & ADU Is Failing
- Slow drip from the tub spout or showerhead: usually a worn cartridge seal inside the Delta valve, not the trim. Ignoring it stains grout and runs up your water bill quietly.
- Water pooling at the base of a wall in the addition: a failed valve or supply line behind the finish. This is the one that turns a $300 part into a drywall-and-tile job if you wait.
- Handle won’t hold temperature: the pressure-balance spool in a Monitor 14 or 17 series valve has degraded. It’s a symptom, not a cause, and it’s fixable before it fails open.
- Mineral crust on Delta trim in Long Beach: our water runs hard, and it eats cartridge seals faster than in softer-water markets. Annual descaling extends life noticeably.
- Mildew smell in the new bath even after cleaning: moisture trapped behind improperly sealed cement board substrate (the moisture-resistant layer behind your tile). This is a build problem, not a part problem.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

For a like-for-like Delta cartridge or valve refresh inside an existing addition, expect $180 – $420 installed, parts and labor included. For larger work tied to the addition itself, these are the Long Beach ranges we quote in writing before any tool comes out:
| Scope | Installed Range |
|---|---|
| Delta valve cartridge / trim refresh | $180 – $420 |
| Bathroom remodel within addition | $9,000 – $28,000 |
| Home addition (full build) | $45,000 – $130,000 |
| ADU construction | $90,000 – $220,000 |
| Garage conversion | $30,000 – $80,000 |
The number moves with foundation type, roof tie-in complexity, and finish level. What doesn’t move is this: the price on day one is the price on the invoice, and the work is covered by the 365-Day Done Right Promise in writing.
DIY or Call Us?
You can safely shut off the supply, photograph the valve, and check for visible corrosion. That’s the useful part of DIY here. Replacing a Delta cartridge or opening a wall behind a shower valve is where it goes wrong: cross-threading the valve body, missing the temperature-limit stop, or failing to address a compromised cement board substrate means water where it shouldn’t be. Penhallow Remodeling Long Beach is an independent service provider, not affiliated with Delta, and we treat every repair as if it were our own wall. Call (833) 510-6967 for a free written estimate.
FAQs

Five to ten years in typical Long Beach water, shorter on high-use showers. Hard water accelerates seal wear, so annual descaling of Delta trim pays for itself.
Often yes: a Delta Monitor cartridge can usually be rebuilt or have its seals swapped before the whole valve comes out. We’ll tell you honestly which route is cheaper over the next five years.
A cartridge swap runs 45 – 90 minutes. A valve replacement behind tile typically takes half a day once the supply is shut off.
OEM Delta parts through authorized distribution, matched to your valve’s stamped series number. We don’t stock parts on trucks or claim to; every part is ordered to your unit.
Whether you’re pricing a full addition or chasing a drip behind Delta trim in Long Beach, you get a written number before we start and a real person on the phone 24/7. Call (833) 510-6967 for your free estimate.
Written by the team at Penhallow Remodeling Long Beach, serving Long Beach and nearby areas.












