







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
IKO Windows & Doors: The Long Beach Owner’s Guide
We install and service IKO windows and doors for Long Beach homeowners, and installed replacement runs $4,500 – $15,000 for a standard window project, or $8,000 – $25,000 for impact-rated units in coastal zones. The call usually comes when a seal fails and the glass fogs, weatherstripping hardens and the door stops latching, or a sill rots from the inside out. That first sign shows up before the water does.
Most owners discover the problem the same way: a draft they can’t trace, a window they can’t get fully shut, or a paint bubble at the bottom corner that turns out to be soft wood behind the trim. The part itself isn’t always the whole story, and we’ll tell you straight when a gasket will do the job and when the unit has reached its end in our Long Beach marine air.
Which IKO Models This Applies To

IKO sells under series labels (think their window lines and entry or patio door models), and the part that matches yours depends on both the series and the vintage. The manufacturer label lives on the top or side of the sash channel on a window, and on the hinge edge or inner frame of a door. Pull the model and series code off that label before anything else. Two windows that look identical from the curb can take different balances, seals, or sill components depending on when they were made.
On the OEM-versus-aftermarket question, IKO factory parts match the tolerances of a specific series and are the safe call for anything structural, like a balance assembly or hinge set. Quality aftermarket weather seals, sweep gaskets, and screen frames can perform just as well and cost less, provided you match profile and thickness. We’re not affiliated with IKO, so our advice is grounded in what actually fits and holds up, not in pushing a brand.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your IKO Windows & Doors Is Failing
- Fogging between the panes. The sealed glass unit lost its inert gas and moisture got in, usually from a failing edge seal. In Long Beach, salt air and daily coastal humidity push that seal harder than inland climates do. This one you can’t fix by cleaning; the glass unit itself has to be replaced.
- Drafts you can’t stop. Worn weatherstripping or a gasket that’s gone flat lets outside air straight through the frame. You’ll feel it near the corner of a window or the edge of a door before you see any damage.
- A door that won’t latch or drags. The hinge set or threshold sweep has worn or shifted, throwing the slab out of alignment. This gets worse with seasonal humidity swings and starts catching the strike plate.
- Rot or soft wood at the sill or frame. Water sitting in the sill pocket, often hidden behind caulk or paint, breaks the wood down from the inside. That’s your frame telling you it’s been taking on moisture for a while.
- Condensation or a cold spot on the inside face. A failing seal or a compromised thermal break lets the interior surface run cold. Persistent condensation in the same spot usually means the unit has lost its energy efficiency.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

For Long Beach, a standard window replacement runs $4,500 – $15,000 depending on how many units, frame material, and whether the frame is sound or the whole unit comes out. Impact window installation, the kind required or chosen in much of coastal Long Beach for wind and debris protection, runs $8,000 – $25,000. Individual parts fixes, like a gasket, sweep, or balance, sit well below those figures, but the honest drivers are always the same: count of openings, frame condition, glazing type, and whether permits are needed.
Our written price covers parts, labor, and cleanup, and it comes before any work starts. What we quote is what the invoice says, with no change orders sneaking in after demo. The work carries our 365-Day Done Right Promise in writing, so if a repair fails inside that window, we come back and make it right at no charge.
DIY or Call Us?
Some jobs are safe for a careful homeowner: checking the label, measuring the opening, cleaning and re-seating weatherstripping, or tightening a loose hinge screw. Where DIY goes wrong on IKO windows and doors is glass unit replacement, frame and sill repair on rotted wood (you rarely know how far the rot runs until the trim comes off), and any door alignment that needs the hinge set resetting. Getting a sealed glass unit out without cracking it or the frame takes the right tools and technique.
If your window or door is failing and you want a straight answer, call (833) 510-6967. We’ll tell you what part you need, whether a repair holds, and give you a written price before anyone picks up a tool.
FAQs

How long do IKO windows and doors last in Long Beach? Expect a sealed glass unit’s seals to hold up 15 – 20 years, while frames and hardware commonly reach 20 – 25 years with care. The coastal marine air and year-round humidity here push the envelope, so we often see seals and weatherstripping go before the frame does. Call (833) 510-6967 for a free estimate on what’s worth repairing versus replacing.
Can it be repaired instead of replaced? Often, yes. A fogging window is a glass-unit swap, a leaky door may just need new weatherstripping and a sweep, and a dragging door can be re-hung. Repair is worth it when the frame and sill are solid. Call (833) 510-6967 and we’ll tell you which side of that line yours is on, at no charge.
How long does the swap take? A single glass unit or door hardware fix is usually a couple of hours, while a full window or door installation depends on the count and permits. For a standard replacement window, that’s typically half a day per opening. Call (833) 510-6967 for a written timeline with your estimate.
How do you source the IKO-compatible part? We pull your series and model code from the label, then match the exact part or a tested aftermarket equivalent. If the original part is discontinued, we find the compatible replacement rather than force a near-fit. Call (833) 510-6967 and we’ll confirm what your unit takes before we quote.
Written by the team at Penhallow Remodeling Long Beach, serving Long Beach and nearby areas.












