







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Cover Driveway & Pavers: The Long Beach Owner’s Guide
We install Cover-compatible driveway and paver systems across Long Beach, and a full pervious paver driveway typically runs $7,000 – $18,000 installed, depending on square footage, base prep and whether the existing slab has to come out first. Most Long Beach owners don’t discover the problem on the surface. They notice it after a rain, when water pools against the garage door instead of draining through the joints, or when a section of pavers near the street starts rocking underfoot every time a car pulls in.
What usually follows is a closer look: joints that have stopped taking sand, a base layer that has settled unevenly, or a runoff line that now runs toward the house instead of away from it. On older Long Beach lots, that’s often the first real signal that the driveway and paver system needs attention rather than another sweep and a fresh layer of sand.
Which Cover Models This Applies To

Cover’s driveway and paver line isn’t one product. The pieces that fail most often – edge restraint, joint sand, base aggregate and the paver units themselves – vary by series, and the profile, thickness and joint width differ between them. Before we quote anything, we identify what’s actually installed. That means checking the original installation paperwork if you have it, measuring paver thickness (common residential profiles run roughly 2 3/8 to 2 3/4 inches), and confirming the joint width the system was laid to. A paver pulled from one series won’t lock correctly into another, and forcing it is how you get a joint that opens again within a season.
On the OEM-versus-aftermarket question, we’re straight with Long Beach homeowners: for base aggregate and joint sand, a quality equivalent from a recognized supplier performs the same as OEM and often costs less. For the paver units themselves and any interlocking edge restraint, matching the original profile matters more than saving a few dollars – a mismatched unit is the most common reason a repair looks fine in June and rocks loose by the following spring. Penhallow Remodeling Long Beach is an independent service provider and is not affiliated with Cover. We also work with KraftMaid, Cambria and Silestone on the interior side, but on the driveway the priority is matching your Cover system spec.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Cover Driveway & Pavers Is Failing
- Water pooling at the garage apron after rain. The base has settled and the slope now runs toward the door instead of the street drain. Left alone, that water finds the foundation and the garage sill.
- Pavers rocking or shifting underfoot. Joint sand has washed out and the bedding layer is no longer holding each unit in place. It spreads – one loose paver usually becomes five within a season.
- Widening joints and weeds pushing through. The edge restraint has failed or pulled away, letting the field spread outward. This is the failure that reads as cosmetic but is really structural.
- Sunken or heaved sections near a tree or utility line. Root growth or a buried line has disturbed the base. Long Beach’s heavy clay soils make this worse after a wet winter, and it won’t settle back on its own.
- Standing water against the house after heavy rain. Drainage has reversed direction, often because the original grade was never corrected. This one is worth a call before the next storm season.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

Here’s what driveway and paver work runs in Long Beach, with the number you get in writing before we touch a paver:
- Paver driveway installation: $7,000 – $18,000
- Concrete driveway installation: $4,500 – $12,000
- Asphalt driveway paving: $3,500 – $9,000
- Driveway replacement: $5,000 – $14,000
- Driveway sealing: $250 – $700
- Paver patio installation: $3,500 – $11,000
What drives the range: total square footage, how much base has to be excavated and rebuilt, whether the existing slab or pavers need hauling off, and whether drainage has to be re-graded to fix the pooling. Sealing at $250 – $700 is the low end and covers protection only – it won’t fix a failed base. Every job gets a written, line-item price up front, so the number on day one is the number on the invoice, and the work is covered by our 365-Day Done Right Promise. If it’s not done right, we come back and make it right at no charge.
DIY or Call Us?
Some checks are safe for any homeowner. Walk the driveway after a rain and note where water sits. Press down on suspicious pavers with your foot to see if they rock. Look at the joint lines along the edge for gaps wider than a finger. Those observations tell us a lot before we arrive.
Where DIY goes wrong is the base. Lifting pavers, re-compacting aggregate and re-setting the slope by hand is heavy, precise work, and a base that’s a quarter-inch off shows up as pooling water the first wet season. A paver repair that doesn’t address the underlying base fails again within a year – usually the same way. That’s the repair that cracks again six weeks later. It’s safer and cheaper in the long run to have the base checked properly. If you’re not sure what you’re looking at, call us at (833) 510-6967 – we’ll tell you honestly whether it’s a repair or a rebuild.
FAQs

How long does a paver driveway last in Long Beach? A properly installed Cover paver driveway with a sound base typically holds up 25 to 30 years or more. The pavers themselves outlast the base most of the time – coastal moisture and the clay soils here are harder on the bedding layer than on the units. Call (833) 510-6967 for an assessment of your specific system.
Can a failing paver section be repaired instead of fully replaced? Often yes. If the base underneath is still sound and only a small section has settled, we can lift and re-set those units without tearing out the whole driveway. If the failure is widespread or the grade is off, a partial repair just postpones the problem. We’ll give you a written price for both so you can decide.
How long does a paver replacement take? A section repair is usually a day. A full driveway replacement typically runs three to six days depending on square footage, excavation and drainage work, and Long Beach permit timelines if any are required. You’ll get an arrival window and a written timeline before we start.
How do you source the replacement part for my Cover system? We identify your Cover series and paver profile first, then source matching units and edge restraint from recognized suppliers, using quality equivalents where the spec allows and OEM-matched units where a mismatched profile would cause a problem. Call (833) 510-6967 for a free estimate.
Whether your Cover driveway and pavers need a section re-set or a full rebuild, you’ll know the price before we start and the guarantee is in writing. Call Penhallow Remodeling Long Beach at (833) 510-6967 for a free estimate – a real person answers, day or night.
Written by the team at Penhallow Remodeling Long Beach, serving Long Beach and nearby areas.












