







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Belgard Driveway & Pavers: The Long Beach Owner’s Guide
Penhallow Remodeling Long Beach installs Belgard-compatible driveways and pavers, with paver driveway installation in Long Beach typically landing between $7,000 and $18,000 and paver patio installation between $3,500 and $11,000. We’re an independent contractor, not affiliated with Belgard, and we price the job in writing before any work starts. Most Long Beach homeowners don’t discover they have a Belgard driveway until it starts failing: a paver pops up by the garage door after a Santa Ana wind event, sand washes out of the joints in the first heavy winter rain, or a wheel load on a soft corner sinks the base. That’s when they go looking for someone who knows the product and can tell them straight whether it’s a repair or a re-lay.
Key takeaways
- Belgard pavers are modular systems – the part that fails is almost always the base or joint, not the paver face.
- Installed paver driveway: $7,000 – $18,000 in Long Beach. Patio: $3,500 – $11,000.
- Written price before work starts; 365-Day Done Right Promise on every project.
- Live person answers the phone 24/7 at (833) 510-6967.
Which Belgard Models This Applies To

Belgard makes pavers in several families, and knowing which one you have matters because the base depth, joint sand type, and edge restraint all change with the profile. The lines most common on Long Beach driveways and patios are the older-style Aspen and Cambridge cobble profiles, the modern Mega-Lafitt and Urbana stone looks, and the tumbled Holland and Bergerac pavers. If you’re not sure, pull one paver and measure it: nominal sizes run about 4×8, 6×9, and 12×12 inches, and thickness for a driveway application is usually 2-3/8 inches (60mm) versus the thinner 1-1/2 to 2-inch units used on patios and walkways. That thickness difference is the compatibility gotcha – a thin paver swapped into a driveway base that was built for 60mm will rock and crack within a season.
On the OEM-versus-aftermarket question: there is no true “aftermarket part” for a Belgard paver in the way there is for an appliance. The paver itself is the product. Where quality matters is in the base aggregate (Class II road base, not fill dirt), the joint sand (polymeric or stabilized, not plain mason sand), and the edge restraint (a proper spiked plastic or concrete curb). A budget re-lay that skips the polymeric sand and the edge restraint is the single most common reason a Long Beach Belgard driveway fails a second time. We source these materials new from recognized trade brands, and we’ll tell you plainly which line your existing pavers match rather than talking you into a full replacement you don’t need.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Belgard Driveway & Pavers Is Failing
- Pavers heaving or rocking underfoot. The base beneath has settled or wasn’t compacted enough at install. In Long Beach’s clay-heavy soils near the coast, this shows up fastest on the low side of a sloped driveway.
- Sand washing out of the joints every rainy season. Plain mason sand erodes; polymeric joint sand locks in. If you’re re-sanding every year, the joint system was the wrong spec.
- Edge pavers spreading away from the driveway. Missing or failed edge restraint lets the field migrate outward under wheel loads. This reads as a row of pavers creeping toward the curb.
- Efflorescence – the white chalky haze. Mineral salts rising through the paver face, common with coastal moisture and irrigation overspray. Sometimes cosmetic, sometimes a sign the base is holding water.
- Cracks radiating from a single paver. One cracked unit usually means a point load over a void – a failed base spot, not a failed paver. A single hairlike crack in a cold joint is normal; a spiderweb pattern is not.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

For Long Beach, here’s what the numbers look like, installed, all-in, with a written price before work starts:
| Job | Typical installed range |
|---|---|
| Paver driveway installation (Belgard) | $7,000 – $18,000 |
| Paver patio installation | $3,500 – $11,000 |
| Driveway replacement | $5,000 – $14,000 |
| Driveway sealing | $250 – $700 |
What drives the range up: square footage, whether the existing base has to come out, slope and drainage correction, and the Belgard profile (tumbled and textured lines cost more than smooth units). What drives it down: reusing sound pavers on a spot repair, or a sealing job on a healthy drive. Your written price covers demolition, base prep, paver and joint sand, edge restraint, and clean-up. The 365-Day Done Right Promise backs the work in writing – if a paver settles or a joint fails inside the year, we come back and fix it at no charge.
DIY or Call Us?
You can safely check a lot yourself: walk the driveway and note where pavers rock, look for missing joint sand after a rain, check whether the edge row is creeping, and measure a pulled paver to identify your Belgard line. A driveway is a heavy, low-fall-risk surface, so a small spot repair isn’t a safety hazard the way roof or electrical work would be. Where it goes wrong is base prep and compaction: a homeowner who re-sands a failed drive without fixing the void underneath just buys one more season. If more than a couple of pavers are rocking, or the edge is spreading, it’s a base problem, and re-laying without digging out and re-compacting the base is money thrown away.
For a real repair or a new Belgard install, call (833) 510-6967 for a free estimate. Every Penhallow job gets a written price before work starts, a real arrival window, and background-checked, uniformed technicians on site. Say the price, show up in the window, leave it cleaner than we found it – that’s The Kingswell Way.
FAQs

A properly installed Belgard paver driveway should last 25-30 years or more in Long Beach’s coastal climate. The pavers themselves outlast the base and joints, which is why re-sanding and edge restraint maintenance matter more than the paver face. Call (833) 510-6967 to have yours looked at.
Yes – most failures are base or joint issues, not failed pavers, so a spot re-lay or re-sand often solves it. A full replacement is only needed when the base is compromised across the whole drive. Call (833) 510-6967 for a free estimate and a straight answer.
A typical paver driveway in Long Beach runs about 3-5 working days for a standard two-car drive, more if the base has to be dug out. Your written quote includes the timeline before work starts. Call (833) 510-6967 to schedule your free estimate.
We source Belgard pavers and base materials new from recognized trade suppliers, matched to your existing line where possible. We don’t carry parts on a truck – the right materials are ordered for your job. Call (833) 510-6967 to talk through your driveway.
If your driveway or patio needs a real answer and a written number, call Penhallow Remodeling Long Beach at (833) 510-6967 for a free estimate. We also work with KraftMaid, Cambria, and Silestone on interior projects, and we’re part of the Kingswell family of companies operating to The Kingswell Way. Every job gets a written price before work starts and the 365-Day Done Right Promise behind it.
Written by the team at Penhallow Remodeling Long Beach, serving Long Beach and nearby areas.












