







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Mighty Buildings Driveway & Pavers: The Long Beach Owner’s Guide
We install Mighty Buildings-compatible driveway and paver systems in Long Beach, and a full paver driveway typically runs $7,000 – $18,000 installed, while a concrete driveway lands between $4,500 and $12,000 depending on square footage and base prep. Replacing worn sections or failed pavers instead of the whole drive often comes in well under that. We’re an independent service provider, not affiliated with Mighty Buildings, but our technicians have up to 22 years of experience with the specific slab, panel, and paver assemblies these homes use.
Owners usually find the problem after a rain. Water pools against the foundation instead of running to the street, a run of pavers has settled into a shallow bowl, or a hairline crack in a panel has widened enough to trip a foot. In Long Beach, the discovery often comes in the first wet season after install, when flat grades and heavy clay soil make drainage problems impossible to ignore.
Key Takeaways
- Paver driveway installation in Long Beach runs $7,000 – $18,000; concrete runs $4,500 – $12,000.
- Section repairs and re-leveling cost far less than full replacement and are usually the right first move.
- Our technicians have up to 22 years of experience with modular and panel-built home assemblies.
- Every job gets a written price before work starts, backed by our 365-Day Done Right Promise.
Which Mighty Buildings Models This Applies To

Mighty Buildings built its reputation on 3D-printed and panelized units, and the exterior hardscape around those homes was engineered to match each model line’s foundation height and grade. The driveway and paver scope differs by series: earlier single-story accessory units and studio models often sit on a shallower slab edge than the two-story residential lines, which changes the depth of the base course and the transition strip at the garage apron. If you’re ordering a replacement paver or a repair panel, the model number on the data plate (usually inside the utility closet or on the exterior near the service panel) tells you which assembly you have.
The OEM-versus-aftermarket call matters here. Mighty Buildings’ original paver spec used a specific thickness and joint pattern that ties into the printed panel edge. A quality aftermarket paver of the same dimensions and compressive rating will perform, but a thinner unit will telegraph and crack at the transition. We measure the existing course, match the thickness and color family from recognized trade brands like Belgard and Unilock, and tell you in writing whether an exact-match OEM piece is realistic or whether a compatible equivalent is the smarter buy. That’s a conversation, not a sales pitch.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Mighty Buildings Driveway & Pavers Is Failing
- Pooling water after rain. The base has settled or the grade has fallen toward the house. In Long Beach’s flat lots and clay soil, a half-inch of settlement is enough to send water the wrong way.
- Pavers rocking or sinking in one area. The bedding sand has washed out or the sub-base wasn’t compacted to depth. This is a repair, not a replacement, but it gets worse fast under a parked car.
- Widening cracks in concrete panels or the apron. Usually a sign of base failure or root heave. A crack you can slip a coin into is telling you the slab underneath has moved.
- Loose or missing joint sand. Weeds sprout in the joints and edges start to migrate. In coastal Long Beach humidity, neglected joints invite both.
- Sunken transition at the garage or street apron. The most common failure we see, and the one most likely to trip someone. It points to base erosion at the highest-traffic edge.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

Here’s what driveway and paver work runs in Long Beach, installed, with the base prep and haul-away included:
- Paver driveway installation: $7,000 – $18,000
- Concrete driveway installation: $4,500 – $12,000
- Asphalt driveway paving: $3,500 – $9,000
- Driveway replacement: $5,000 – $14,000
- Driveway sealing: $250 – $700
- Paver patio installation: $3,500 – $11,000
The range comes down to square footage, how much base has to be excavated, and whether you’re matching an existing paver line or starting fresh. We give you a written price before any work starts, so the number on day one is the number on the invoice. Each job carries a written guarantee, and our 365-Day Done Right Promise means if the work fails inside the year, we come back and fix it at no charge.
DIY or Call Us?
Some things you can safely check yourself: look for standing water after rain, press on pavers to see if any rock underfoot, and note where cracks open widest. That tells us a lot on the phone. What we’d steer you away from is pulling up a run of pavers or breaking out a concrete panel to “see what’s under it.” Base failure and grade problems are the real cause, and re-setting pavers over a bad base just buys you a few months. Matching a Mighty Buildings panel edge also takes the right thickness and compaction, and a DIY patch that’s half an inch off will pond water straight at your foundation.
If your driveway is draining toward the house or a paver run has gone soft, call us at (833) 510-6967. A live person answers around the clock, we’ll give you a real arrival window, and the estimate is free.
FAQs

How long does a Mighty Buildings paver driveway last in Long Beach? A properly based paver driveway should hold 25 years or more, but in Long Beach’s clay soil and coastal moisture the base is what fails first, not the pavers. If the base was compacted short, you’ll see settlement within the first few wet seasons. Re-leveling early protects the pavers themselves.
Can it be repaired instead of replaced? Yes, and often it should be. A sunken transition, a rocking run, or a handful of cracked pavers are repair jobs, not replacement jobs. We’ll tell you in writing whether a repair will actually solve the problem or just delay a bigger one. Call (833) 510-6967 for a free assessment.
How long does the swap take? A section repair is usually a one-day job. A full paver or concrete driveway replacement in Long Beach typically runs two to four days depending on square footage, excavation, and cure time. You get the schedule in writing before we start, and we keep the arrival window we give you.
How do you source the part? We measure your existing assembly, confirm the model from the data plate, and match thickness and color from recognized trade brands. If an exact OEM match isn’t realistic, we tell you plainly and quote a compatible equivalent. We don’t carry parts on a truck or stock them locally; we source to your spec. Call (833) 510-6967 for a free estimate.
When you’re ready, call (833) 510-6967. We’ll give you a written price before any work starts, arrive in the window we promised, and stand behind the job with our 365-Day Done Right Promise. We also work with KraftMaid, Cambria, and Silestone on the interior side if a driveway project turns into a bigger remodel.
Written by the team at Penhallow Remodeling Long Beach, serving Long Beach and nearby areas.












