







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
ViewLux Driveway & Pavers: The Long Beach Owner’s Guide
We install ViewLux-compatible driveway and paver systems across Long Beach, and most full paver driveways run $7,000 – $18,000 installed, with sealing at $250 – $700 as an add-on. If you’re reading this because a paver has rocked loose, a joint is washing out, or water is pooling against the garage, you’re in the right place. The symptom that finally gets homeowners to call us is almost always the same: a paver shifts under a tire after a rain, or the sand between units starts disappearing down the storm drain on a slope. Both point to a base or joint problem, not a surface cosmetic. Penhallow Remodeling Long Beach is an independent service provider and is not affiliated with ViewLux.
Key Takeaways
- Most ViewLux paver driveway failures in Long Beach trace to base prep and joint sand, not the pavers themselves.
- Installed paver driveways in Long Beach typically cost $7,000 – $18,000; sealing alone is $250 – $700.
- We source ViewLux-compatible units from recognized hardscape makers like Belgard and Unilock when a true match matters.
- You get a written price before any work starts and a 365-Day Done Right Promise on the job.
Which ViewLux Models This Applies To

ViewLux sells interlocking concrete pavers through several product lines, and the important thing to know is that the base and joint system matters more than the specific face style when you’re replacing or extending a driveway. The failure you’re chasing is usually under the paver, so matching the surface is only half the job.
To identify what you have, pull one edge paver where it meets the driveway apron and measure the length, width and thickness in millimeters. Most residential driveway pavers are 60mm or 80mm thick; a driveway carrying a full-size SUV should be 80mm. If your existing units are 60mm and you’re replacing, going thicker where the tire tracks sit is worth discussing. Check the underside of a unit for a stamped mark or the imprint of the manufacturer mold, and keep one pulled paver in a bucket as your reference piece.
On the OEM-versus-aftermarket question for ViewLux: if you need a handful of matching pavers to repair a small area, an exact ViewLux match is the cleanest path. If you’re redoing a whole driveway or a large field, a quality aftermarket paver in a compatible thickness and joint profile is entirely workable, and we regularly specify Belgard or Unilock units alongside the existing system. We don’t stock parts or carry pavers on a truck; we source what your job needs and bring it to the site with the price written down first.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your ViewLux Driveway & Pavers Is Failing
- Pavers rocking or dipping under a tire. The bedding layer has thinned or the base compacted unevenly, so a unit no longer sits flat. This is a base problem, not a paver problem.
- Joint sand washing out after rain. Polymeric or regular joint sand is eroding because water is running across the surface instead of off it, often on a driveway sloped toward the street. Long Beach’s winter rain events push this fast.
- Water pooling against the garage or foundation. The driveway pitch has fallen below the 1 – 2% slope you want draining away from the house, and water is now sitting where it shouldn’t.
- Weeds sprouting from joints. Organic matter has filled the joint and the sand barrier is gone, which means the interlock is already loosening.
- Chipped edges or a paver cracking along the tire line. Point loads from a heavy vehicle over a thin base or a 60mm unit will crack it; this is where thickness and base depth on a ViewLux driveway matter most.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

For Long Beach, here’s what the numbers look like, and every one of these is a written price before work starts, not a range that moves at the door.
- Paver driveway installation: $7,000 – $18,000
- Concrete driveway installation: $4,500 – $12,000
- Asphalt driveway paving: $3,500 – $9,000
- Driveway replacement: $5,000 – $14,000
- Driveway sealing: $250 – $700
- Paver patio installation (if you’re extending the system): $3,500 – $11,000
What pushes a ViewLux paver driveway toward the top of the range: more square footage, thicker 80mm units, significant base excavation and haul-off, a retaining edge or curb, and drainage corrections on a sloped lot. Materials and labor are broken out on your quote so you can see the split. Every job carries our 365-Day Done Right Promise in writing, and if a repair fails inside the guarantee period we come back and fix it at no charge, with a free return visit and no service-call fee.
DIY or Call Us?
Replacing a single cracked paver on a flat, well-drained section is genuinely doable for a handy homeowner: lift the unit, reset the bedding sand, compact, re-sand the joints. Where it goes wrong is base work and water management, and that’s the part that governs whether the ViewLux system lasts. Running new pavers over a failed base just fails again in a season or two. If your driveway has a slope, a drainage issue, or more than a couple of loose units, this is a base and grading job that needs a crew who does it every week. Swap-labor aside, there’s no hidden DIY trap here that risks injury, but a bad base is expensive to redo. Call (833) 510-6967 and we’ll look at the drainage and give you a written number for what it actually needs.
FAQs

A well-installed paver driveway with a proper 4 – 6 inch compacted base and correct joint sand should hold up for decades; the pavers themselves outlast almost everything else. The joint sand and base are what typically need attention first, often a re-sand and reseal in the $250 – $700 range. Call (833) 510-6967 for an exact quote on your driveway, and estimates are free.
Yes, and often should be. Loose or sunken units over a localized base issue can be lifted, re-bedded and re-sanded for far less than a full replacement, and sealing alone runs $250 – $700. A full replacement at $5,000 – $14,000 makes sense only when the base has failed across the whole field or drainage can’t be corrected in place. Call (833) 510-6967 for a free look and a written recommendation.
A typical Long Beach driveway replacement runs a few days of work across the site, with base excavation, compaction, paving and joint sand in sequence, and it’s weather-dependent because wet base material won’t compact properly. We give you a defined arrival window and keep the job moving. Call (833) 510-6967 to schedule your free estimate.
We pull from recognized hardscape makers, including Belgard and Unilock for compatible paver and base materials, and reference your existing units by thickness and joint profile to get a match. We don’t claim to stock ViewLux parts or carry pavers on a truck; we order what the job needs and bring it to your site with a written price up front. Our technicians have up to 22 years of experience, arrive background-checked and in uniform, and every job is backed by the 365-Day Done Right Promise. Call (833) 510-6967 for your free estimate.
If your ViewLux driveway has a paver rocking, a joint washing out, or water sitting where it shouldn’t, call Penhallow Remodeling Long Beach at (833) 510-6967 for a free estimate. We’ll tell you the written price before any work starts, and we won’t try to sell you a replacement your driveway doesn’t need. We also work with KraftMaid, Cambria and Silestone for the projects that extend past the driveway.
Written by the team at Penhallow Remodeling Long Beach, serving Long Beach and nearby areas.












